Engine Generators & AC Switchgear

Engine Generators & AC Switchgear				CI Solar Supplies Co. Online Catalog
Returnto CI Division >>>>>	CIHome	Radio/ Telecom	Electro-Serv	InvestWay	CISolar Supplies	SatelliteCo.	IrriGatorCo.

Genmate - - Automatic Start Controller An automatic generator controller which works with any 2, 3, or 4 wire remote controlled engine generator. User selectable settings are adjustable for start voltage, stop voltage, generator type, number of start attempts, exercise cycling, prestart warning, and remote control overide. Voltage settings are adjustable from 10.0V-15.0V in 0.1V increments for 12 V nominal systems (double for 24V in 0.2V increments). AC confirmation through a provided AC to DC adapter assures start. Alarms indicate failure to start, low battery, exercise cycle activation, start alert, and invalid settings. The GenMate also can be setup to slave to water pump demand when used with a float or pressure switch. The unit requires 8-32 VDC and uses only 30mW @12VDC in idle mode. Mounted in a water proof plastic enclosure.
Model Number	Description	Dimensions (inches)	Wt. (lbs)	List Price	Qty 2	Qty 6
PR/SS-GENMATE	GenMate with water proof box	9 x 11 x 3.5	4	Listed for Reference
Generator Start Control Module
The GSCM-mini is a micro-proscessor based generator star-stop module, designed to auto start-stop high speed gas generators needing a 3 wire connection from a 2 wire manual start command. Idt automatically disconnects the starter when a minimum generator AC Hz. output is measured. It can monitor the generator's output for an over odr under Hz condition an shut it down if either is detected. The Gen. Hz LED is blinks to indicate the cause of the shutdown. Manually resetting the GSCM-mini by removing the power, removes any fault shutdown and allows the generator to restart if called to do so. The GSCM-mini is powered by 12VDC from the generator battery, and can monitor the battery voltage and start the generator to charge it's own battery, All Thresholds are fixed. The GSCM-mini is a limited function controller, part of the GSCM family. If adjustability is required use the GSCM full function Generator Start Control Module.
Model Number	Description	Dimensions (inches)	Wt. (lbs)	List Price	Qty 2	Qty 6
	Micro-processor generator	5.13" x 2.853" x 1.35"	20 OZ	Call	Call	Call
The GSCM is a fully programmable micro-processor generator start controller. It accepts auto or manual commands and monitors multiple start/stop fault conditions
Model Number	Description	Dimensions (inches)	Wt. (lbs)	List Price	Qty 2	Qty 6
	Micro-processor generator	5.5" x 3.3" x 1.5"	20 OZ	Call	Call	Call

Generac - - Engine Generators Available in sizes of 8KW, 10KW, 15KW, 20KW and 25KW. Available in Diesel (8KW only) or Liquid Propane (LPG) models. LPG 8KW are air cooled and include: System controls, muffler, main line circuit breaker, trickle type battery charger, flex fuel line and weather protective enclosure. All other models are liquid cooled and include: System and controls instrumentation, muffler, flex fuel line, MLCB, 500 watt coolant heater, flex exhaust, trickle type battery charger and outdoor enclosure Liquid cooled models include protection for overspeed/low oil, high temp, low coolant shutdown and overcrank. All models as listed include 2-wire remote start/stop control. Limited 1 year warranty. Extended warranties available.
Model Number	Power	Amps @ 120/240	Fuel	Fuel Rate	RPM	Dimen	Ship Wt.(lbs)	List Price	Qty 2	Qty 6
EG/GN-EPS-8D	8kW	66/33	Diesel	0.88 Gal/Hr	1800	44 x 25 x 29	592	$13,081	11118.85	9810.75
EG/GN-EPS-8-AC	8kW	66/33	LPG	1.8 Gal/Hr	3600	37.5 x 22.7 x 26.5	447	$6,639	5643.15	4979.25
EG/GN-EPS-10	10kW	83/41	LPG	2.2 Gal/Hr	1800	49 x 25 x 33	890	$9,579	8142.15	7184.25
EG/GN-EPS-15	15kW	192/62	LPG	3.1 Gal/Hr	1800	49 x 25 x 33	925	$10,666	9066.10	7999.50
EG/GN-EPS-20	20kW	166/83	LPG	4.0 Gal/Hr	3600	49 x 25 x 33	928	$11,949	10156.65	8961.75
EG/GN-EPS-25	25kW	208/104	LPG	4.8 Gal/Hr	3600	49 x 25 x 33	930	$13,186	11208.10	9889.50

Todd Engineering - - Power Transfer Switch
ETL Automatic transfer switches have 120VAC coils (2 to 3 W consumption) mounted in a plastic enclosure with a variety of knock-outs. Built-in 30 second time delay with LED to allow generator warm up. Must be used with circuit distribution panel with main breakers rated at or below the Power Switch rating. Electrical connections are made to 12 ga. stranded pigtails/ ETL C listed to UL 1008 and CSA 22.2 #178 standards. Two year limited warranty.

Model Number

Description

Generator Size

Dimensions

Ship Wt.

List Price

Qty 2

Qty 6

SG/TD-TS30

2 pole,120VAC, 30A

4 KW

7.5 x 8.5 x 4

3 lbs.

Listed for Reference
See IOTA Replacement
Below

SG/TD-TS50

2 pole,120VAC,50A (240VAC,30A)

7 KW

7.5 x 8.5 x 4

4 lbs.

Listed for Reference
See IOTA Replacement
Below

SG/TD-PS245S

4 pole, 120/240VAC, 50A per Pole

12 KW

7.5 x 8.5 x 4

4 lbs.

Listed for Reference
See IOTA Replacement
Below

SG/TD-PS262S

3 pole,120/240VAC, 60A per Pole

14 KW

Listed for Reference
See IOTA Replacement
Below

IOTA Engineering ITS Transfer Switches The ITS Series Transfer Switches from IOTA provide automatic power supply switching for a variety of applications. Switch between AC powercords, onboard generators, onboard inverters, or all three. Switching is automatic. The ITS senses the presence of the available supplies and automatically selects the proper one, providing safe and appropriate levels of power at all times. And the ITS comes in a variety of models for use in a wide range of power applications. Models available include Relay-Based (R) and Contactor-Based (C) switches, and also units designed for special applications. In addition, all ITS Transfer Switches are backed by our standard two-year warranty.
Model No.	Description	Price	Qty 2-5 each	Qty 6-up each
ITS-30R	30 amp Transfer Switch	$63.00	53.55	47.25
ITS-50R	50 amp Transfer Switch	$156.00	132.60	117.00
ITS-75C		$
ITS-100R		$

Time Delays for AC Loads Use to allow generator to warm up before activating a load. Fast-on terminal connections. For loads greater than rated amperage, use external contactors.
Model Number	Voltage	Load Amperage	Time Delay Range	Dimensions	Ship Wt.	List Price	Qty 2	Qty 6
PR/SA-HRDM423	120 VAC	20A	6 sec - 10 min	2 x 3 x 1.5	1 lb.	$56.00	47.60	42.00
PR/SA-TSD1621	230 VAC	40mA-1A	1-100 sec	2 x 3 x 1.5	1 lb.	$53.65	45.60	40.25
PR/SA-2A562	120 VAC	10mA-1A	3 - 60 sec	2 x 2 x 1.3	1 lb.	$25.60	21.75	19.20

Trace - - Model T240 Transformer Autoformer 120/240 VAC, step-up or step-down, rated at 4.5 kW continuous. Includes input and output breakers with space for additional AC load breakers.
Model Number	Description	Dimensions "	Wt. (lbs)	List Price	Qty 2	Qty 6
PI/TE-T240	4.5KW Trace Transformer	21 x 6.1 x 7	45	350	297.50	262.50

CI Solar Supplies Co, PO Box 2805, Chino, CA 91710 (909) 628-6440 jclothi@attglobal.net