FEATURES	BENEFITS
Generator Start Controller	Automatically starts/stops generator based on Battery Voltage, Load Size Amps, or Time of Day. Many user set features including: Quiet Time, Must Start Override, Warmup Seconds, Max Crank Seconds, Max Start Attempts.
Standby Power	Functions as an Uninterruptable Power Supply with <34ms transfer time.
Generator Support	Automatically switches from charger to inverter, to assist generator output when large loads are turned on.
Battery Voltage Triggered Transfer	Allows automatic charger activation when battery voltage falls below setpoint (current compensated).
Utility Interactive - (Requires Utility Company Approval)	Sell back times and amperage can be user set.
Peak Load Shaving	Allows grid usage times to be set to non-peak rate times.
Standard models include efficient 3-stage adjustable battery charger with temperature compensation (probe included).

• Suitable for Grid-Tied and Off-Grid Applications
• Split phase 120/240 Vac output from a single inverter
• Non-volatile flash memory
• High efficiency: 95% peak, CEC 93%
• High surge capacity (double the inverter rating for 7 seconds)
• Dual AC inputs (Gen & Grid)
• Grid quality waveform – not a stepped approximation.
• Power factor corrected battery charger increases efficient use of AC charging                     sources. Back plate mounting system for ease of installation.

Power Distribution Panel provides integrated switchgear for AC, DC and
communications wiring. Wiring is pre-connected, measured and labeled for
field simplicity. Easily configured for multiple inverter installations.
Allows up to 3 inverters and 4 charge controllers per system.

XW-MPPT60 New Maximum Power Point Tracking PV Charge Controller
Built-in PV Ground fault protection supports battery voltages from 12 to 60VDC.
Support array voltages up to 150 VDC maximum open circuit.

SCP System Control Panel provides access to control settings and monitoring of
all devices on a system network – “Xanbus” (standard Cat 5 cable) with no need
for a hub or power cubes. Display is 128 x 64 pixel backlit LCD screen with user
friendly menu system. The SCP comes with mounting plates for flush and
stand-off mounting.SCP can be removed once system is programmed.

Accessories-
XW Connection Kit for additional inverter – includes inverter conduit box, AC
and DC breakers and wires.

XW Automatic Generator start for 2 or 3 wire generator configurations.

Xanbus to USB Adapter - allows for updating of firmware or programming of
the system using a local PC

Limited 5-year warranty
Board level replacements and swap reimbursement of $75 payable to Energy
Club members for warrantable failures.

Xantrex GT Series Inverters
As of May 2007, The available models of GT inverters will be GT2800, GT3300, GT4000 and GT5000. These models are 240 Vac but are also field configurable for 208Vac. The wattage rating decreases when used in a 208 Vac applicationl. All models include a lockable DC and AC disconnect integrated into the unit. Wide DC input voltage range allows for maximum flexibility in array designs. Passive cooled with large integrated vertical mounted heat sink. Neutral beige NEMA 3R enclosure.
Two line 16 character Liquid Crystal Display (LCD) provides instantaneous power, daily and lifetime energy production, PV array voltage and current, utility voltage and frequency, time online “selling” today, fault messages, and installer customizable screens LCD vibration sensor allows the tap of a finger to turn backlight on and display screen cycling. Bright LED indicators provide system status at a glance. Integrated RS232 and Xanbus RJ45 communication ports PC software for remote monitoring and system troubleshooting FCC Part B compliance. Warranty 10-year standard.

See: Sol-Gen Systems for Approved Array Configurations